节点文献

低温燃烧合成Al₂O₃-LaPO₄复合粉体及其陶瓷性能研究

Low-temperature Combustion Synthesis of Al₂O₃-LaPO₄ Composite Powders and the Properties of the Composite

推荐 CAJ下载
PDF下载
不支持迅雷等下载工具，请取消加速工具后下载。

【Author】 GONG Guo-Liang, ZHANG Bao-Lin, LI Wen-Lan, ZHUANG Han-Rui ( Structural Ceramics Engineering Center of Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, China;Graduate University, Chinese Academy of Sciences, Beijing 100049, China)

【机构】中国科学院上海硅酸盐研究所结构陶瓷工程研究中心；中国科学院上海硅酸盐研究所结构陶瓷工程研究中心上海 200050 中国科学院研究生院；北京 100049；上海 200050；

【摘要】以Al(NO3)3、LaPO4和柠檬酸为原料,采用低温燃烧方法合成Al2O3-LaPO4复合粉体．在相同热压烧结条件下,ALC50(采用燃烧法合成的复合粉体)相对密度比ALM50(采用球磨混合的复合粉体)提高2．5％,达到98．5％．断口形貌分析显示ALC50中晶粒(平均0．56μm)明显比ALM50中晶粒(平均1．74μm)细化．ALC50的强度、韧性分别比ALM50增加11．1％、11．2％,而硬度基本相同．由于弱界面的增加,ALC50钻孔速率比ALM50提高近50％．更多还原

【Abstract】 Al2O3-LaPO4 composite powders were synthesized by low-temperature combustion synthesis using Al(NO3)3, LaPO4 and citric acid as raw materials. The relative density of hot-pressed ALC50(prepared by combustion-synthesized powders) was 98.5% and improved 2.5% in comparision with ALM50 (prepared by ball-milling of powders mixtures). It is shown that the average grain size of ALC50(0.56μm) is much smaller than that of ALM50 (1.74μm). The bending strength and fracture toughness of ALC50 are respectively increased by 11.1% and 11.2% while the hardness of ALC50 is almost the same. The drilling rate of ALC50 increases by approximately 50% as compared with that of ALM50 due to the increasement of weak interface.更多还原