节点文献

退火方式对低压电解质电容器铝箔微量元素的分布和腐蚀性能的影响

Effect of Annealing Method on Microelements Distribution and Corrosion Performance of Aluminum Foil for Low Voltage Electrolytic Capacitor

  • 推荐 CAJ下载
  • PDF下载
  • 不支持迅雷等下载工具,请取消加速工具后下载。

【作者】 吕亚平毛卫民杨宏冯惠平

【Author】 Lü Ya-ping~1,MAO Wei-min~(1,2),YANG Hong~1,FENG Hui-ping~1(1.Department of Materials,University of Science and Technology Beijing,Beijing 100083,China;2.State Key Laboratory of Advanced Metals and Materials,University of Science and Technology Beijing,Beijing 100083,China)

【机构】 北京科技大学材料科学与工程学院材料学系北京科技大学材料科学与工程学院材料学系 北京100083北京100083北京科技大学新金属材料国家重点实验室

【摘要】 观察了经400℃真空退火保温1 h后分别随炉冷却和空冷的低压铝箔表面的电化学腐蚀结构,检测相应的比电容,利用二次离子质谱仪检测了铝箔表面区域Mg、Si、Cu微量元素的分布。结果显示,在炉冷的条件下,微量元素在铝箔表面的浓度比空冷条件下的高,且分布比较均匀。在空冷条件下,微量元素更容易偏聚在表面的轧制纹、晶界等缺陷处,使箔样在轧制纹处出现不均匀腐蚀结构,不利于比电容的提高。

【Abstract】 The surface electrochemical corrosion structures of aluminum foils for low voltage electrolytic capacitor,observed after being annealed at 400 ℃ for 1h followed by furnace cooling and air cooling respectively.The specific capacity of the etching foils was measured,and the distribution of microelements Mg,Si and Cu in the surface layer was determined by secondary ion mass spectrometer.The results show that the microelement concentration in the surface layer is higher and its distribution is more uniform after furnace cooling than that after air cooling.Furthermore,the microelements are segregated more easily around the scribed rolling striations and grain boundary after air cooling,which results in inhomogeneous corrosion and low specific capacity.

【关键词】 铝箔微量元素偏聚轧制纹腐蚀
【Key words】 aluminum foilmicroelementsegregationscribed rolling striationcorrosion
【基金】 国家自然科学基金(50571020);教育部博士点基金(20040008010)
  • 【文献出处】 金属热处理 ,Heat Treatment of Metals , 编辑部邮箱 ,2006年12期
  • 【分类号】TG156.2
  • 【被引频次】3
  • 【下载频次】173
节点文献中: 

本文链接的文献网络图示:

本文的引文网络