【摘要】 针对感应测井信号的处理与分析，采用DIT-FFT方法引入寻峰算法设计了基于VS2015环境的信号频谱检测软件。推导了FFT算法计算频率、幅度、相位的理论公式，利用C#语言实现数据读入、波形显示、幅频显示（测量）、相频显示（测量）、报表生成等功能。在搭建的软件平台中利用噪声叠加、整周期采样和非整周期采样，对软件抗噪性、稳定性进行量化检验。结果表明，该频谱分析软件在信噪比低至5 dB的噪声干扰环境下进行整周期采样检测时，信号幅度的相对误差不大于0.31%，相位相对误差不大于1.14%，非整周期采样时，幅值相对误差不超过0.49%及相位相对误差不超过1.39%，满足工程测量要求。更多还原

【Abstract】 For the processing and analysis of induction logging signal, a signal spectrum detection software based on VS2015 environment is designed by adopting DIT-FFT method and introducing peak searching algorithm. The theoretical calculation formulas of frequency, amplitude and phase using FFT algorithm are derived, and data reading, waveform display, amplitude-frequency display(measurement), phase-frequency display(measurement), report generation and other functions are finished in C# language. In the software platform, the anti-noise and stability of the software are quantitatively tested by noise superposition, integral period sampling and nonintegral period sampling. The results show that when to use the software performs integral cycle sampling under the noise interference environment with signal-to-noise ratio as low as 5 d B, the relative error of the amplitude is no more than 0.31% and the relative error of phase is no more than 1.14%, and when performing non integral cycle sampling, the relative error of amplitude and phase is no more than 1.39%, which meets the requirements of engineering measurement.更多还原