【摘要】 本文采用离子束溅射方法制备GdF₃薄膜,并研究其沉积速率分布特征。首先,采用膜厚仪测量得出GdF₃薄膜在行星盘平面的二维沉积速率分布图,通过拟合模型得到二维沉积速率分布公式。其次,分析了束流束压及靶材角度对沉积速率分布特征的影响。最后,以二维沉积速率分布公式为基础,通过计算机编程设计均匀性挡板,并进行膜厚均匀性实验验证。结果表明,沉积速率在水平方向上满足ECS函数分布,在竖直方向上满足标准Gauss分布,拟合公式残差为2.05×10^-6。改变离子源的束流和束压,沉积速率分布特征保持不变。而随着靶材角度的增大,Gauss分布的半峰宽值ω逐渐增大,峰值位置x_c逐渐增大,在θ=292°时,GdF₃薄膜的沉积速率最大。通过挡板修调实验,可将270 mm口径平面元件的膜厚均匀性调整为97.9%。更多还原

【Abstract】 The deposition rate distribution of single GdF₃ layer deposited by ion beam sputtering（ IBS） has been investigated in this paper. First,Two dimension deposition rate distribution of GdF₃ thin films are measured by an UV-film thickness measuring instrument,and the expression of two dimension deposition rate distribution are obtained by using fitting models. Second,the influence of beam current,beam voltage and the angle of target on deposition rate distribution feature is analyzed. Finally,the experiments of thickness uniformity have been carried out using designed mask,based on the expression of two dimension deposition rate. Experimental results indicate that the deposition rate in horizontal direction is satisfied with the ECS function. And in vertical direction it is satisfied with standard Gauss function. The residual error of fitting expression is 2. 05 ×10^-6. The feature of deposition rate distribution remains the same when the beam current and beam voltage are changed. With the increase of the target angle,the value of peak width at half height of Gauss function are increased. The peak position is changing,and the maximum of deposition rate can be reached when the target angle is 292°. The thickness uniformity is adjusted to 97. 9% for a plane element with radius of 270 mm by using mask.更多还原