A differential low-voltage high gain current-mode integrated RF receiver front-end

【摘要】 <正>A differential low-voltage high gain current-mode integrated RF front end for an 802.11b WLAN is proposed.It contains a differential transconductance low noise amplifier（G_m-LNA） and a differential current-mode 0 down converted mixer.The single terminal of the G_m-LNA contains just one MOS transistor,two capacitors and two inductors.The gate-source shunt capacitors,C_x1 and C_x2,can not only reduce the effects of gate-source C_gs on resonance frequency and input-matching impedance,but they also enable the gate inductance L_g1,2 to be selected at a very small value.The current-mode mixer is composed of four switched current mirrors.Adjusting the ratio of the drain channel sizes of the switched current mirrors can increase the gain of the mixer and accordingly increase the gain of RF receiver front-end.The RF front-end operates under 1 V supply voltage.The receiver RFIC was fabricated using a chartered 0.18μm CMOS process.The integrated RF receiver front-end has a measured power conversion gain of 17.48 dB and an input referred third-order intercept point（IIP3） of-7.02 dBm.The total noise figure is 4.5 dB and the power is only 14 mW by post-simulations.更多还原

【Abstract】 A differential low-voltage high gain current-mode integrated RF front end for an 802.11b WLAN is proposed.It contains a differential transconductance low noise amplifier（G_m-LNA） and a differential current-mode 0 down converted mixer.The single terminal of the G_m-LNA contains just one MOS transistor,two capacitors and two inductors.The gate-source shunt capacitors,C_x1 and C_x2,can not only reduce the effects of gate-source C_gs on resonance frequency and input-matching impedance,but they also enable the gate inductance L_g1,2 to be selected at a very small value.The current-mode mixer is composed of four switched current mirrors.Adjusting the ratio of the drain channel sizes of the switched current mirrors can increase the gain of the mixer and accordingly increase the gain of RF receiver front-end.The RF front-end operates under 1 V supply voltage.The receiver RFIC was fabricated using a chartered 0.18μm CMOS process.The integrated RF receiver front-end has a measured power conversion gain of 17.48 dB and an input referred third-order intercept point（IIP3） of-7.02 dBm.The total noise figure is 4.5 dB and the power is only 14 mW by post-simulations.更多还原