节点文献

铝合金调速器盖压铸模具热循环的数值模拟

Thermal Cycling Simulation of Die Casting Die for Aluminum Alloy Speed Governor Cover

  • 推荐 CAJ下载
  • PDF下载
  • 不支持迅雷等下载工具,请取消加速工具后下载。

【作者】 谭雁清李日王斌马军贤崔启玉张耀

【Author】 Tan Yanqing1,Li Ri1,Wang Bin1,Ma Junxian2,Cui Qiyu2,Zhang Yao3(1.School of Material Science and Technology,Hebei University of Technology,Tianjin,China;2.China Branch of the ESI,Beijing,China;3.Diesel Engine Factory of Datong,Datong,China)

【机构】 河北工业大学材料科学与工程学院ESI中国分公司大同柴油机厂

【摘要】 利用ProCAST软件对铝合金调速器盖压铸模具工作时的热循环进行数值模拟。模拟结果发现,模具稳定工作时的温度及取件时的温度均偏高。经过多次热循环模拟,不断调整循环参数,最后将循环周期从60s调整为80s。结果表明,模具稳定工作时的最高温度由340℃降低到300℃以下,平均温度下降约20℃,模具工作温度及取件温度均降低到允许的温度范围之内,计算结果与实际生产现场的参数调整后结果相吻合。

【Abstract】 Thermal cycling of die casting die for aluminum alloy speed governor cover was simulated by the ProCAST software.The simulated results indicate that temperature in the die during steady operation stage and temperature during castings-picked out exhibit higher.Cycling parameters were optimized from 60 s per cycling period to 80 s per cycling period by thermal cycling simulation.It is found that the maximum temperature in the die during steady operation stage is decreased from 340℃ to below 300℃,decreased by approximately 20℃ in average temperature,and both die operation temperature and castings-picked-out temperature are decreased to a desirable temperature range.The simulated results are well in agreement with practical ones.

  • 【文献出处】 特种铸造及有色合金 ,Special Casting & Nonferrous Alloys , 编辑部邮箱 ,2009年11期
  • 【分类号】TG249.2
  • 【被引频次】1
  • 【下载频次】123
节点文献中: 

本文链接的文献网络图示:

本文的引文网络